Internet Engineering Task Force (IETF) D. Walton Request for Comments: 7964 Cumulus Networks Category: Standards Track A. Retana ISSN: 2070-1721 E. Chen Cisco Systems, Inc. J. Scudder Juniper Networks September 2016 Solutions for BGP Persistent Route Oscillation Abstract Routing information reduction by BGP Route Reflection or Confederation can result in persistent internal BGP route oscillations with certain routing setups and network topologies. This document specifies two sets of additional paths that can be used to eliminate these route oscillations in a network. Status of This Memo This is an Internet Standards Track document. This document is a product of the Internet Engineering Task Force (IETF). It represents the consensus of the IETF community. It has received public review and has been approved for publication by the Internet Engineering Steering Group (IESG). Further information on Internet Standards is available in Section 2 of RFC 7841. Information about the current status of this document, any errata, and how to provide feedback on it may be obtained at http://www.rfc-editor.org/info/rfc7964. Copyright Notice Copyright (c) 2016 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Walton, et al. Standards Track [Page 1] RFC 7964 BGP Oscillation Solutions September 2016 Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2 2. Requirements Language . . . . . . . . . . . . . . . . . . . . 3 3. Advertise All the Available Paths . . . . . . . . . . . . . . 3 4. Advertise the Group Best Paths . . . . . . . . . . . . . . . 3 5. Route Reflection and Confederation . . . . . . . . . . . . . 4 5.1. Route Reflection . . . . . . . . . . . . . . . . . . . . 5 5.2. Confederation . . . . . . . . . . . . . . . . . . . . . . 5 6. Deployment Considerations . . . . . . . . . . . . . . . . . . 6 7. Security Considerations . . . . . . . . . . . . . . . . . . . 6 8. References . . . . . . . . . . . . . . . . . . . . . . . . . 7 8.1. Normative References . . . . . . . . . . . . . . . . . . 7 8.2. Informative References . . . . . . . . . . . . . . . . . 7 Appendix A. Why the Group Best Paths Are Adequate . . . . . . . 8 Acknowledgements . . . . . . . . . . . . . . . . . . . . . . . . 9 Authors' Addresses . . . . . . . . . . . . . . . . . . . . . . . 9 1. Introduction As documented in [RFC3345], routing information reduction by BGP Route Reflection [RFC4456] or BGP Confederation [RFC5065] can result in persistent Internal BGP (IBGP) route oscillations with certain routing setups and network topologies. Except for a couple of artificially engineered network topologies, the MULTI_EXIT_DISC (MED) attribute [RFC4271] has played a pivotal role in virtually all known persistent IBGP route oscillations. For the sake of brevity, we use the term "MED-induced route oscillation" hereafter to refer to a persistent IBGP route oscillation in which the MED plays a role. In order to eliminate MED-induced route oscillations and to achieve consistent routing in a network, a route reflector or a confederation Autonomous System Border Router (ASBR) needs to advertise more than just the best path for an address prefix. Our goal is to identify the necessary set of paths for an address prefix that needs to be advertised by a route reflector or a confederation ASBR to prevent the condition. In this document, we describe two sets of paths for an address prefix that can be advertised by a BGP route reflector or confederation ASBR to eliminate MED-induced route oscillations in a network. The first set involves all the available paths, and would achieve the same routing consistency as the full IBGP mesh. The second set, which is a subset of the first one, involves the neighbor-AS-based Group Best Paths, and would be sufficient to eliminate MED-induced route oscillations (subject to certain commonly adopted topological constraints). Walton, et al. Standards Track [Page 2] RFC 7964 BGP Oscillation Solutions September 2016 These paths can be advertised using the mechanism described in ADD-PATH [RFC7911] for advertising multiple paths. No other assumptions in functionality beyond the base BGP specification [RFC4271] are made. 2. Requirements Language The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC2119]. 3. Advertise All the Available Paths Observe that in a network that maintains a full IBGP mesh, all the BGP speakers have consistent and equivalent routing information. Such a network is thus free of MED-induced route oscillations and other routing inconsistencies such as forwarding loops. Therefore, one approach is to allow a route reflector or a confederation ASBR to advertise all the available paths for an address prefix. Clearly this approach would yield the same amount of routing information and achieve the same routing consistency as the full IBGP mesh in a network. In this document, "Available Paths" refers to the advertisement of all the available paths. This approach can be implemented using the mechanism described in ADD-PATH [RFC7911] for advertising multiple paths for certain prefixes. For the sake of scalability, the advertisement of multiple paths should be limited to those prefixes that are affected by MED-induced route oscillation in a network carrying a large number of alternate paths. A detailed description of how these oscillations can occur can be found in [RFC3345]; the description of how a node would locally detect such conditions is outside the scope of this document. 4. Advertise the Group Best Paths The term "neighbor-AS" for a route refers to the neighboring autonomous system (AS) from which the route was received. The calculation of the neighbor-AS is specified in Section 9.1.2.2 of [RFC4271], and Section 5.3 of [RFC5065]. By definition, the MED is comparable only among routes with the same neighbor-AS. Thus, the route selection procedures specified in [RFC4271] would conceptually involve two steps: first, organize the paths for an address prefix into groups according to their respective neighbor-ASes, and Walton, et al. Standards Track [Page 3] RFC 7964 BGP Oscillation Solutions September 2016 calculate the most preferred one (termed "Group Best Path") for each of the groups; then, calculate the overall best path among all the Group Best Paths. As a practice that is generally recommended (in [RFC4456] and [RFC5065]) and widely adopted, a route reflection cluster or a confederation sub-AS should be designed such that BGP routes from within the cluster (or confederation sub-AS) are preferred over routes from other clusters (or confederation sub-AS) when the decision is based on the IGP cost to the BGP NEXT_HOP. This is typically done by setting IGP metrics for links within a cluster (or confederation sub-AS) to be much smaller than the IGP metrics for the links between the clusters (or confederation sub-AS). This practice helps achieve consistent routing within a route reflection cluster or a confederation sub-AS. When the aforementioned practice for devising a route reflection cluster or confederation sub-AS is followed in a network, we claim that the advertisement of all the Group Best Paths by a route reflector or a confederation ASBR is sufficient to eliminate MED-induced route oscillations in the network. This claim is validated in Appendix A. Note that a Group Best Path for an address prefix can be identified by the combination of the address prefix and the neighbor-AS. Thus, this approach can be implemented using the mechanism described in ADD-PATH [RFC7911] for advertising multiple paths, and in this case, the neighbor-AS of a path may be used as the path identifier of the path. It should be noted that the approach of advertising the Group Best Paths requires certain topological constraints to be satisfied in order to eliminate MED-induced route oscillation. Specific topological considerations are described in [RFC3345]. 5. Route Reflection and Confederation To allow a route reflector or a confederation ASBR to advertise either the Available Paths or Group Best Paths using the mechanism described in ADD-PATH [RFC7911], the following revisions are proposed for BGP Route Reflection and BGP Confederation. Walton, et al. Standards Track [Page 4] RFC 7964 BGP Oscillation Solutions September 2016 5.1. Route Reflection For a particular
, a route reflector MUST include the